Washer Woes Part 2 - How To Replace A Water-inlet Valve
Below is a MRR and PLR article in category Home Family -> subcategory Home Improvement.
Washer Woes: Part 2 - How to Replace a Water-Inlet Valve
Summary
Achieving clean clothes depends largely on water temperature and detergent choice. If your washer struggles with regulating water temperature, the culprit might be your water-inlet valve.
Article
Keeping your clothes spotless requires the right water temperature and detergent. If your washer has issues regulating water temperature, it's likely that your water-inlet valve is the problem. In this guide, we'll cover how to examine, test, and replace this crucial component.
Understanding the Water-Inlet Valve
Water enters the inlet valve through two hoses connected to your home's hot and cold water taps. Inside the valve, solenoids respond to your temperature selections, mixing hot and cold water to achieve the desired temperature before it flows into your washer through a common hose.
Safety First
Before any maintenance, ensure your washer is unplugged to avoid serious injury.
Checking Water Flow
The water inlet valve is located at the back of the washer's cabinet:
1. Turn off both water taps.
2. Disconnect hoses from the washer and place their ends in a bucket.
3. Turn the taps back on to check for proper water flow and ensure hoses are unblocked.
Removing and Examining the Valve
If water flow is adequate, proceed to the valve:
1. Unscrew the two screws securing the valve.
2. Detach the washer fill hose by loosening the clamp.
3. Use a flat-head screwdriver to carefully remove the valve's inlet screens and inspect for debris. Clean them without damaging the screens.
Testing the Valve
If screens are clear, it's time to test the valve:
1. Label and disconnect the wires attached to each solenoid terminal.
2. Check for corrosion or rust. If present, replace the valve.
3. Use a multimeter set to the ohms resistance scale (X1) for continuity testing:
- Touch each meter probe to a solenoid's terminals.
- A reading of infinity indicates a damaged solenoid, necessitating replacement.
Installing a New Valve
To replace the valve:
1. Attach the fill hose to the new valve.
2. Secure with screws and connect the wires to the solenoid terminals.
3. Reconnect the hot and cold water hoses.
4. Turn on the water and check for leaks before running a wash cycle.
Final Thoughts
If you're unable to diagnose the problem or lack the tools, consider contacting a professional service technician. Replacing the valve often resolves water temperature issues effectively.
You can find the original non-AI version of this article here: Washer Woes Part 2 - How To Replace A Water-inlet Valve.
You can browse and read all the articles for free. If you want to use them and get PLR and MRR rights, you need to buy the pack. Learn more about this pack of over 100 000 MRR and PLR articles.